E-TERNITY² V250, Full GRP Electric Glider, ARF+
Wingspan 2500mm, D-Power # ETV250V2

All-rounder flying characteristics:
The E-TERNITY² V250 has excellent all-rounder characteristics thanks to its aerodynamic design and modified airfoil. The V-tail gives the electric glider maximum stability and neutral flight behavior. The model can be stably maneuvered through all common aerobatic figures and also performs very well in thermals. With the top-hinged flaps, the E-TERNITY² can also be flown very slowly and landed safely.

High-quality construction:
The E-TERNITY² V250 is made from a gel-coated GRP fuselage. The wings and V-tail are also entirely made of GRP. In addition, components subjected to particularly high loads are reinforced with carbon. The built-in MULTIlock® wing locking system provides additional support for the wings, and thanks to the built-in MPX high-current connectors, the wings can be quickly removed.

High ARF+ prefabrication level:
Spend minimal time in the workshop and maximum time at the airfield. The ARF+ prefabrication level takes care of the most time-consuming tasks. All wiring is completely laid, so electronic components only need to be connected to the pre-installed wiring harness and the receiver accordingly. In addition, all control horns are pre-installed, the GRP motor bulkhead for geared motors is glued in, and the battery board and servo mounts are factory-installed. Construction is therefore almost limited to the installation of your preferred electronics.

Features:

• Electric glider with great all-round flying characteristics
• with V-tail and top-hinged flaps
• fully manufactured in high-quality GRP shell construction
• CFRP reinforcements in fuselage and wings
• Solid carbon wing spar
• modified RG14 airfoil
• gel-coated GRP fuselage
• gel-coated GRP wings with modern design
• GRP canopy
• good visibility thanks to high-contrast block stripes on the underside of the wings
• short construction time thanks to high ARF+ prefabrication level

ARF+ Features:

• Wiring harness pre-installed and integrated
• glued-in GRP motor bulkhead for geared motors
• pre-installed servo frames
• MULTIlock® wing locking system installed
• MPX® high-current connectors installed in fuselage and wings
• pre-bent carbon fiber linkages, all control horns pre-installed
• laser-cut battery board pre-installed in the fuselage
• richly illustrated, German-language assembly instructions

Required Accessories:

• Motor: D-Power D-DRIVE IL28-2800 4:1 geared motor
• Controller: D-Power AVICON 50A Brushless
• Battery: 3S LiPo 2200mAh (11.1V)
• Folding propeller: 15 x 10“ @3S
• Aileron Servos: 2x D-Power DS-840BBMG
• Flap Servos: 2x D-Power DS-840BBMG
• V-tail Servos: 2x D-Power DS-220BBMG
• Transmitter and Receiver: at least 8 channels