E-TERNITY² V300, Full GRP Electric Glider, ARF+
Wingspan 3000mm, D-Power # ETV300V2

All-rounder flight characteristics:
Thanks to its aerodynamic design and modified wing profile, the E-TERNITY² V300 has excellent all-rounder characteristics. The V-tail gives the electric glider maximum stability and neutral flight behavior. The model can be maneuvered stably through all common aerobatic figures and also performs very well in thermals. With the flaps hinged from above, the E-TERNITY² can also be flown very slowly and landed safely.

High-quality construction:
The E-TERNITY² V300 is made from a GRP fuselage painted in the mold. The wings and V-tails are also completely made of GRP. In addition, components with particularly high loads are reinforced with carbon. The built-in MULTIlock® wing locking system gives the wings additional support, and thanks to the built-in MPX high-current connectors, the wings can be quickly removed.

High ARF+ prefabrication level:
Spend minimal time in the workshop and maximum time at the airfield. The ARF+ prefabrication level takes care of the most time-consuming work. All wiring is completely laid, so that electronic components only need to be connected to the pre-installed wiring harness and the receiver. In addition, all control horns are pre-installed, the GRP motor bulkhead for geared motors is glued in, and the battery board and servo mounts are factory-installed. Construction is thus almost exclusively limited to the installation of your preferred electronics.

Features:

• Electric glider with great all-rounder flight characteristics
• with V-tail and flaps hinged from above
• completely made in high-quality GRP shell construction
• CFRP reinforcements in fuselage and wings
• Solid carbon wing spar
• modified RG14 wing profile
• GRP fuselage painted in the mold
• GRP wings painted in the mold with modern design
• GRP canopy
• good visibility thanks to high-contrast block stripes on the underside of the wings
• short construction time thanks to high ARF+ prefabrication level

ARF+ Features:

• Wiring harness pre-installed and integrated
• Glued-in GRP motor bulkhead for geared motors
• Pre-installed servo frames
• MULTIlock® wing locking system installed
• MPX® high-current connectors installed in fuselage and wings
• Pre-drilled carbon fiber linkages, all control horns pre-installed
• Laser-cut battery board pre-installed in the fuselage
• Richly illustrated, German-language assembly instructions

Required accessories:

• Motor: D-Power D-DRIVE IL28-2800 4:1 geared motor
• Controller: D-Power AVICON 50A Brushless
• Battery: 4S LiPo 2200mAh (14.8V)
• Folding propeller: 13 x 8" @4S
• Aileron servos: 2x D-Power DS-840BBMG
• Flap servos: 2x D-Power DS-840BBMG
• V-tail servos: 2x D-Power DS-220BBMG
• Transmitter and receiver: at least 8 channels