Japanese Saw with Pull Stroke System, 270mm Blade

Ideal for fine and precise sawing in hardwood, softwood, plywood, PVC, and ABS. The high-quality saw blade also has a reinforced spine.

This pull saw is an original "Shark SAW" from Takagi & Co. from Japan. Not a cheap replica, but the original with the highest cutting performance, quality, and durability.

The quality is designed for commercial use and demanding DIY enthusiasts. The saw blade can be removed by pressing the red button.

The Pull Stroke System:

• allows precise, straight, and controlled cuts (a normal "pushing" saw blade tends to break out sideways unless clamped on both sides)
• easy start when beginning a cut
• Extremely precise and particularly close-fitting cuts are possible, even for producing perfect contact surfaces when sawing miters, scarf joints, or steps for overlapping glue joints.

Extremely thin saw blade (0.6mm):
Therefore, particularly fine and highly precise cuts are possible. Very little effort is required when sawing.

Special tooth pattern:
particularly clean cuts thanks to the special SHARK saw tooth pattern with 3 cutting edges, extremely sharp, diamond-ground tooth tips, thereby significantly reducing "fraying" of the cut edges, no or significantly less risk of coatings or laminated plastics breaking out, clean cut surface, therefore no or significantly reduced post-processing

Special material and processing:
Saw blade made of high-quality carbon steel, chrome-plated surface, the electronically impulse-hardened teeth allow up to 10 times longer service life.

Technical data:

• Usable length of the saw blade: 27cm
• Saw blade thickness: only 0.6 mm thick
• Cutting width: only 0.9 mm
• Teeth per inch: 17 (fine teeth, for fine and thin cuts)
• Tooth geometry: Saw teeth ground and hardened on 3 sides with diamond
• Area of application: for hard and softwood, plywood, PVC,