Kavan VIBE BLUE, 3D Aerobatic Park Flyer
Wingspan 1000mm, # KAV02.8028

VIBE is a powerful biplane 3D aerobatic park flyer made of EPP foam, powered by a 350-500 W brushless electric motor. A few hours with superglue in hand are all it takes to complete this model. You can then enjoy F3A standard category figures as well as 3D aerobatics! The model is also suitable for less experienced pilots. With smaller throws, anyone with at least some aerobatic experience who can reliably fly loops, turns, and rolls can fly it. Thanks to the model's low weight, not too much damage occurs in an accident – and EPP parts are easily repairable!

The one-piece wing with large ailerons has a symmetrical profile. Carbon fiber spars ensure strength, and of course, there are ready-made servo bays in the lower wing.
The strut of the pylon for the upper wing, reinforced with plywood parts, is part of the fuselage; the struts between the wings are made of EPP with carbon fiber reinforcements. The fuselage is profiled with a horizontal section reinforced with carbon fiber profiles. The vertical section with a large side area ensures perfect knife-edge flight.
The well-thought-out design includes a plywood motor mount attached to the fuselage with carbon fiber profiles. Servo bays for elevator and rudder are housed in the fuselage.
The tail surfaces are also made of EPP with carbon fiber reinforcements. The ailerons, rudder, and elevator are controlled by short, direct carbon fiber or steel linkages.
The main landing gear is made of carbon fiber with two lightweight wheels and EPP covers. It is mounted with two screws to a fiberglass support plate, which is attached to the fuselage with fiberglass holders. The tail skid with a 3D-printed console and a lightweight foam wheel is connected to the rudder.

To control the model, you will need at least a 4-channel RC set that allows for dual rate and exponential throw settings.

Included in the kit:

• printed fuselage, wing, tail, and landing gear cover parts made of EPP foam
• a plywood motor mount
• 3D printed plastic parts
• carbon fiber reinforcements
• control horns, clevises, linkages, and other small accessory parts
• carbon fiber landing gear with lightweight wheels
• a detailed instruction manual with many illustrations

Required accessories:

• 4 MIDI servos (12mm)
• Brushless motor ø28mm approx. 1000KV
• Brushless ESC
• LiPo battery 3S 1000mAh