Danger

Hazard statements:

H222 Extremely flammable aerosol.
H229 Pressurised container: May burst if heated.
H315 Causes skin irritation.
H336 May cause drowsiness or dizziness.

Precautionary statements:

P101 If medical advice is needed, have product container or label at hand.
P102 Keep out of reach of children.
P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources.
No smoking.
P211 Do not spray on an open flame or other ignition source.
P251 Do not pierce or burn, even after use.
P410+P412 Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122 °F.
P501 Dispose of contents/container according to regional regulations.

Additional information:

EUH066 Repeated exposure may cause skin dryness or cracking. Explosive mixtures possible without adequate ventilation.

PALETTI Synthetic Resin Lacquer Spray, Cub Yellow Glossy, 400ml

Areas of application:
Suitable for wood, metal, paper, glass, GfK, foil, plastic (Lexan), EPO, EPP, Elapor

Quality: High-quality synthetic resin lacquer

Features:

• Quick-drying
• High opacity and filling power
• Permanent colour and gloss retention
• Scratch, shock and impact resistant
• Excellent adhesion
• Resistant to synthetic oils
• Heat resistant up to approx. 75°C

 Drying times: All drying times refer to room temperature (= +20°C to 22°C).
Depending on the thickness of the applied lacquer coat, drying times may differ from the stated times.
When in doubt, allow the paint to dry for longer!

Application:
Surface preparation:
The surface must be clean, dry, and grease-free (wash Lexan with acetone). Sand and prime with filler.
Allow to dry for 1-2 hours.

General painting: Bring the can to room temperature. Shake well before use and spray a test area. Spray several thin coats at intervals of approx. 2 minutes. Spraying distance approx. 25cm.

Painting one colour:
Multiple coats of the same colour can be sprayed one over another within 2 hours. Do not overpaint between 2 and 24 hours.

Painting multiple colours over each other:
The colour to be overpainted must always be dry.
Waiting time between the first and second colour: approx. 24 hours.

Caution:
Do not spray on acrylic paint and do not spray with acrylic paint.

Drying:  * dust dry after approx. 30 min
                     * tack-free after approx. 3 hours
                     * fully dry after approx. 24 hours

Coverage: 400 ml is sufficient for approx. 1 m², depending on the colour shade and opacity.

Recommendation: Only spray in dry weather and in wind-protected areas, as well as in well-ventilated rooms. Temperatures preferably between +15°C and +25°C.

Disposal: Only place completely emptied cans in the recycling container. Bring lacquer cans that are not emptied to the hazardous waste collection point.

Tip: When painting small areas, we recommend using a cardboard box as a template, into which a hole slightly larger than the area to be painted is cut. Hold the cardboard about 1-2 cm above the area. This method largely catches the overspray.

Important: This application information is provided to the best of our knowledge. However, it is only intended as non-binding guidance and does not relieve the user from conducting their own tests regarding suitability for the intended applications. Application and processing are beyond our control and therefore fall exclusively within the user's responsibility.