Danger

Hazard statements:

H222 Extremely flammable aerosol.
H229 Pressurised container: May burst if heated.
H315 Causes skin irritation.
H336 May cause drowsiness or dizziness.

Precautionary statements:

P101 If medical advice is needed, have product container or label at hand.
P102 Keep out of reach of children.
P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources.
No smoking.
P211 Do not spray on an open flame or other ignition source.
P251 Do not pierce or burn, even after use.
P410+P412 Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122 °F.
P501 Dispose of contents/container in accordance with regional regulations.

Additional information:

EUH066 Repeated exposure may cause skin dryness or cracking. Explosive mixtures may form without adequate ventilation.

PALETTI Synthetic Resin Lacquer Spray, Clear Lacquer Matt, 400ml

Areas of application:
Suitable for wood, metal, paper, glass, GRP, foil, plastic (Lexan), EPO, EPP, Elapor

Quality: High-quality synthetic resin lacquer

Properties:

• Quick-drying
• high opacity and filling power
• permanently colour and gloss stable
• scratch, impact and shock resistant
• excellent adhesion
• resistant to synthetic oils
• heat resistant up to approx. 75°C

 Drying times: All drying times refer to room temperature (= +20°C to 22°C).
Depending on the thickness of the applied paint layer, drying times may differ from the stated times.
If in doubt, allow the paint to dry longer!

Application:
Surface pre-treatment:
The surface must be clean, dry and grease-free (wash Lexan with acetone). Sand and prime with filler.
Allow to dry for 1-2 hours.

Painting in general: Bring the can to room temperature. Shake vigorously before use and test spray. Spray several thin coats at intervals of approx. 2 minutes. Spraying distance approx. 25cm.

Painting one colour:
Several coats of the same colour can be sprayed over each other within 2 hours. Do not overcoat between 2 hours and 24 hours.

Painting several colours over each other:
The colour to be overcoated must be dry.
Waiting time between first and second colour: approx. 24 hours.

Attention:
Do not spray on acrylic lacquer and do not spray with acrylic lacquer

Drying:  

• dust-dry after approx. 30 min
• tack-free after approx. 3 hours
• thoroughly dry after approx. 24 hours

Yield: 400 ml is sufficient for approx. 1 m² depending on the shade and opacity

Recommendation: Only spray in dry weather and in sheltered areas, as well as in well-ventilated rooms. Temperatures should ideally be between +15°C and +25°C

Disposal: Only place the completely empty can in the recycling bin. Bring the non-empty can to the hazardous waste collection point.

Tip: When painting small areas, we recommend using a cardboard box as a template, in which a hole slightly larger than the area to be painted is cut. The cardboard is held approx. 1-2 cm above the area. With this method, a significant part of the spray mist is intercepted.

Important: This application information is provided to the best of our knowledge. However, it is only intended as non-binding advice and does not release the user from their own tests regarding suitability for the intended application. Application and processing are beyond our control and are therefore exclusively the responsibility of the user.