Danger

Hazard statements:

H222 Extremely flammable aerosol.
H229 Pressurised container: May burst if heated.
H315 Causes skin irritation.
H336 May cause drowsiness or dizziness.

Precautionary statements:

P101 If medical advice is needed, have product container or label at hand.
P102 Keep out of reach of children.
P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources.
No smoking.
P211 Do not spray on an open flame or other ignition source.
P251 Do not pierce or burn, even after use.
P410+P412 Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122 °F.
P501 Dispose of contents/container in accordance with regional regulations.

Additional information:

EUH066 Repeated exposure may cause skin dryness or cracking. Explosive mixtures may form without adequate ventilation.

PALETTI Synthetic Resin Lacquer Spray, Leaf Green matt, 400ml

Areas of application:
Suitable for wood, metal, paper, glass, GRP, foil, plastic (Lexan), EPO, EPP, Elapor

Quality: High-quality synthetic resin lacquer

Properties:

• Quick-drying
• high opacity and filling power
• permanently colourfast and gloss-retaining
• scratch, impact and shock resistant
• excellent adhesion
• resistant to synthetic oils
• heat-resistant up to approx. 75°C

 Timings: All timings refer to room temperature (= +20°C to 22°C).
Depending on the thickness of the applied lacquer layer, drying times may differ from the stated times.
In case of doubt, let the lacquer dry longer!

Application:
Surface pre-treatment:
The surface must be clean, dry and grease-free (wash Lexan with acetone). Sand and prime with filler.
Allow to dry for 1-2 hours.

General lacquering: Bring can to room temperature. Shake vigorously before use and test spray. Spray several thin coats at intervals of approx. 2 minutes. Spray distance approx. 25cm.

Lacquering one colour:
Several coats of the same colour can be sprayed over each other within 2 hours. Do not overcoat between 2 and 24 hours.

Lacquering several colours over each other:
The colour to be overcoated must always be dry.
Waiting time between first and second colour: approx. 24 hours.

Caution:
Do not spray on acrylic lacquer and do not spray with acrylic lacquer

Drying:  

• dust dry after approx. 30 min
• tack-free after approx. 3 hours
• through-dried after approx. 24 hours

Coverage: 400 ml is sufficient for approx. 1 m² depending on colour shade and opacity

Recommendation: Spray only in dry weather and in sheltered areas, as well as in well-ventilated rooms. Temperatures preferably between +15°C and +25°C

Disposal: Only place completely empty cans in the recycling container. Take cans that are not empty to a hazardous waste collection point.

Tip: When lacquering small areas, we recommend using cardboard as a template, into which a hole slightly larger than the area to be lacquered is cut. Hold the cardboard approx. 1-2 cm above the area. With this method, a significant part of the spray mist is captured.

Important: This application information is provided to the best of our knowledge. However, it is only a non-binding guide and does not exempt the user from their own tests regarding suitability for the intended application. Application and processing are beyond our control and are therefore the sole responsibility of the user.