Danger

Hazard statements:

H222 Extremely flammable aerosol.
H229 Pressurised container: May burst if heated.
H315 Causes skin irritation.
H336 May cause drowsiness or dizziness.

Precautionary statements:

P101 If medical advice is needed, have product container or label at hand.
P102 Keep out of reach of children.
P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources.
No smoking.
P211 Do not spray on an open flame or other ignition source.
P251 Do not pierce or burn, even after use.
P410+P412 Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122 °F.
P501 Dispose of contents/container according to regional regulations.

Additional information:

EUH066 Repeated exposure may cause skin dryness or cracking. Without sufficient ventilation, explosive mixtures may form.

PALETTI Synthetic Resin Lacquer Spray, Pastel Blue glossy, 400ml

Areas of application:
Suitable for wood, metal, paper, glass, GRP, foil, plastic (Lexan), EPO, EPP, Elapor

Quality: High-quality synthetic resin lacquer

Properties:

• Quick-drying
• high opacity and filling power
• permanently colourfast and gloss-retaining
• scratch, impact and shock resistant
• excellent adhesion
• resistant to synthetic oils
• heat resistant up to approx. 75°C

 Drying times: All drying times refer to room temperature (= +20°C to 22°C).
Depending on the thickness of the applied lacquer layer, drying times may vary from the specified times.
In case of doubt, allow the lacquer to dry longer!

Application:
Surface pre-treatment:
the surface must be clean, dry and grease-free (wash Lexan with acetone). Sand and prime with filler.
Allow to dry for 1-2 hours.

General lacquering: Bring can to room temperature. Shake well before use and spray a test. Spray several thin coats at intervals of approx. 2 minutes. Spraying distance approx. 25cm.

Lacquering one colour:
Several coats of the same colour can be sprayed over each other within 2 hours. Do not overcoat between 2 and 24 hours.

Lacquering multiple colours over each other:
The colour to be overcoated must be dry.
Waiting time between first and second colour: approx. 24 hours.

Attention:
Do not spray on or with acrylic lacquer.

Drying:  * dust-dry after approx. 30 min
                     * tack-free after approx. 3 hours
                     * fully dry after approx. 24 hours

Yield: 400 ml is sufficient for approx. 1 m², depending on the colour shade and opacity.

Recommendation: Only spray in dry weather and in sheltered areas, as well as in well-ventilated rooms. Temperatures preferably between +15°C and +25°C.

Disposal: Only place the completely emptied can in the recycling container. Take lacquer cans that are not emptied to a hazardous waste collection point.

Tip: When painting small areas, we recommend using a piece of cardboard as a stencil, with a hole cut slightly larger than the area to be painted. Hold the cardboard approx. 1-2 cm above the area. With this method, a significant part of the spray mist is captured.

Important: This application information is provided to the best of our knowledge. However, it is only intended as non-binding advice and does not relieve the user from their own tests regarding the suitability for the intended applications. The application and processing are beyond our control and are therefore exclusively the responsibility of the user.