uniLIGHT round 10mm Flashing Light Module, RED, 8W, 8 (12) Volts with various caps Red 8W spot light with two clear polycarbonate caps (10mm and 24mm).

The module comes pre-wired with an aluminum mounting plate for cooling and assembly. Also included is an additional small heat sink for alternative mounting with minimal dimensions. For extended operation, please pay close attention to temperatures; for the 8W module, the use of both the cooling plate AND the heat sink is strongly recommended. Only the desired cap and the heat sink need to be glued on with superglue. The 10mm cap serves as light distribution for concealed installation behind a GRP wall, while the 24mm cap can be used for external mounting as it completely covers the module. An additional polycarbonate profile extension is included as an accessory, which can optionally be glued to the 10mm cap.

An appropriate control electronics is required for operation, which MUST be set to strobe impulse!

Technical data:

• Electrical: 8W reference power 8 (12) V, 0.7A
• Beam angle: >160°
• Luminous intensity: ~90 lumens RED
• Base plate dimensions: 20x50mm
• Additional heatsink dimensions: 15x15x6mm
• Small cap: ø10x12mm
• Large cap: ø24x10mm
• Weight: 8g (without cable)

Scope of delivery:

• With 1m connection cable, ready for connection to 2S, resistor for 3S Lipo included
• Protective caps

Reference power specifications are a pure comparative value between the offered illuminants. They usually refer to an operating voltage of 12V/3S Lipo and depend on the illuminant, operating mode, and technology. Please note that high-power LEDs can get very hot; up to 70°C is completely normal. Check operating temperatures after installation. No warranty is assumed for overheating.

Caution: The LED lights are extremely bright! Never look directly into an LED; risk of retinal damage!